User manual
Table Of Contents
- Preface
- Emergency first aid
- Manufacturer
- Contents
- Notes, cautions and warnings
- About this guide
- Introduction
- Getting started
- Paper recommendations
- Loading paper
- User authentication and access control
- Operation
- Copying
- Scanning
- Scan to e-mail
- Scan to network PC
- Scan to USB memory
- Scan to local PC
- Scan to remote PC
- Managing profiles
- Managing the address book
- Setting sender and reply to e-mail addresses (from/reply to)
- Creating e-mail templates
- Adding an e-mail address entry to the address book
- Deleting an e-mail address entry from the address book
- Modifying an e-mail address entry from the address book
- Adding a group entry to the address book
- Deleting a group address entry from the address book
- Modifying a group address entry from the address book
- Printing
- Faxing
- Functions common to copy, fax and scan operations
- Maintenance
- Installing upgrades
- Troubleshooting
- Specifications
- Appendix A - menu system
- Index
- Muratec contact details

Appendix A - menu system > 158
Network
Menu (cont.)
Network Setup
(cont.)
Gateway Address xxx.xxx.xxx.xxx Current assigned
gateway address. To
change, proceed as
above.
Display condition:
TCP/IP protocol must
be enabled.
DNS Server (Primary) user defined The IP address of your
DNS server (primary).
DNS Server (Secondary) user defined The IP address of your
DNS server
(secondary).
WINS Server (Primary) user defined The IP address of your
WINS server
(primary).
WINS Server
(Secondary)
user defined The IP address of your
WINS server
(secondary).
Web Enable Enables or disables
web config. facility.
Display condition:
TCP/IP protocol must
be enabled.
Tel n e t Disable Enables or disables
Telnet config. facility.
Display condition:
TCP/IP protocol must
be enabled.
FTP Disable Enables or disables
communication via
FTP.
Display condition:
TCP/IP protocol must
be enabled.
IPSec Disable Enable via the web
page or Configuration
Too l .
SNMP Enable Enables or disables
SNMP of FTP (TCP/IP
or NetWare).
Display condition:
TCP/IP protocol must
be enabled.
ITEM OPTION DEFAULT VALUE/DESCRIPTION