Data Sheet

LBAD0ZZ1SE Data Sheet, v1.0, 10/05/2020 Page 16 of 26 www.murata.com

9.5 Labeling Requirements

Any device incorporating this module must include an external, visible, permanent marking or label which states:

“Contains FCC ID: HSW-TY1SCDM” and “Contains IC :4492A-TY1SCDM”

Obligation d'étiquetage du produit final:

Tout dispositif intégrant ce module doit comporter un externe, visible, marquage permanent

ou une étiquette qui dit: "Contient IC : 4492A-TY1SCDM”

9.6 Additional Testing Requirements

The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant,

and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not

covered by the modular transmitter grant of certification.

The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.

9.7 Test Modes

Murata Manufacturing Co., Ltd.uses various test mode programs for test set up which operate separate from production

firmware. Host integrators should contact Murata Manufacturing Co., Ltd.for assistance with test modes needed for

module/host compliance test requirements.

Federal Communications Commission (FCC) Statement

15.21

You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void

the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1) this device may not cause harmful interference and

2) this device must accept any interference received, including interference that may cause undesired operation of the

device.

ISED

Canadian Notice

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic

Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired operation of the

device.

Avis Canadien

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences

et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée

aux deux conditions suivantes :

1. L’appareil ne doit pas produire de brouillage;

2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en

compromettre le fonctionnement.