Datasheet

14
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
sales representatives or product engineers before ordering.
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
!Note
S15E.pdf
08.10.31
5
Caution in use
1. (Notice in design)
1) The transducer may generate surge voltage by
mechanical or thermal shock.
2) Please do not apply D.C.voltage for ultrasonic
transducer to avoid migration.
3) Please do not use this ultrasonic sensor in water.
2. (Notice in handling and storage)
1) Please do not apply an excessve mechanical shock
for this ultrasonic transducer.
Please do not apply excessive force on the top of this
ultrasonic transducer and terminal pins.
2) The products should not be used or stored in a
corrosive atmosphere, especially where chloride gas,
sulfide gas, acid, alkali, salt or the like are present.
Store the products in the room where is normal
temperature and humidity, and avoid the sunlight,
sudden changes in temperature and humidity.
It may cause of failure or malfunction in such
conditions.
3) Please do not use and storage this ultrasonic sensor
in hevy dust and high humidity condition. Store
the products where the temperature and relative
humidity do not exceed -10 to 40 degrees centigrade,
and 15 to 95%RH.
Use the products within 6 months after receiving.
3. (Notice in mounting)
1) Please do not apply excessive force for terminals,
when soldering.
2) Use soldering iron to mount. Don't exceed 350 degC,
3second. Soldering point should be more than 2mm
below from the bottom of ultrasonic transducer
body.
3) Please do not clean by water and dissolvent.