Datasheet
Specification No.: JEGI1-0151 19/20
.
Rev.3.00
In any other place similar to the above (a) through (h).
14-2 保管および使用時
14-2 Notice in handling and storage
1) 当センサの光学フィルタを汚したり、傷をつけないで下さい。
Optical filter of sensor should not be scratched or soiled.
2) センサ本体、および、端子部に強い衝撃を与えないで下さい。
Strong shock should be avoided.
3) 静電気や、強い電磁波等のある場所で保管しないで下さい。
Electrostatics and strong electromagnetic field should be avoided.
4) 端子を、導電性のテーピングエンボスから外した状態で保管しないで下さい。
Sensor should be kept on conductive sponge.
5) 高温、多湿、塵埃の多い場所、液体中(水、有機溶媒等)、腐蝕性ガス(亜硫
酸ガス、窒素酸化物ガス等)及び、潮風の存在する場所で保管しないで下さい。
High temperature, high humidity, fluid as water or alcohol etc., corrosive gas
( S0
2
, Cl
2
, NO
X
etc.) and sea breeze should be avoided.
6) 保管環境は、周囲温度-10~40℃、相対湿度15~95%とし、納入後6ヶ月以内
にご使用下さい。
Use the products within 6 months after receiving.
14-3 実装時
14-3 Notice in mounting
1)はんだ付け後の洗浄は行わないでください。また光学フィルタに汚れが付着しな
いようにして下さい。光学フィルタの汚れは誤動作の原因となります。
Cleaning after reflow soldering should not be applied.
Optical filter of sensor should not be soiled because it may cause failure or
malfunction.
2) 当製品は、一度でも限度を超えた高温状態になると、特性を失い機能しなくなり
ます。当納入仕様書記載の条件を越えた温度が加わらないように実装して下さい。
Please follow soldering conditions described in the specification. This product can
permanently stop operating if the piezoelectric(pyroelectric) characteristic is
decreased due to excessive heating.