Datasheet

One heat stress shown in the right profile is applied to
resonator, then being place in natural condition for 1 hour,
resonator shall be measure.
1. Pre-heating conditions shall be +140 to +160°C for 60
to 120 seconds. Ascending time up to +150°C shall be
longer than 30 second.
2. Heating conditions shall be within 20 seconds at
+230°C min., but peak temperature shall be Iower than
+240°C.
1. Soldering Condition
(1) Reflow
HCFC, Isopropanol, Tap water, Demineralized water,
Cleanthrough750H, Pine alpha 100S, Techno care FRW
Some series are not withstand washing.
Please check the right list before use.
2. Wash
(1) Cleaning Solvent
dT<=60°C (dT=Component-solvent)
*1 ex. In case the component at +90°C immerses into
cleaning solvent at +60°C, then dT=30°C.
(2) Temperature Difference : dT *1
5 minutes max. by air blow at +80°C max.
(4) Drying
1. Total washing time should be within 10 minutes.
2. Please insure the component is thoroughly evaluated
in your application circuit.
3. The component may be damaged if it is washed with
chlorine, petroleum, or alkali cleaning solvent.
(5) Others
1. Ultrasonic Wash
1 minute max. in above solvent at +60°C max.
(Frequency : 28kHz, Output : 20W/L)
2. Immersion Wash
5 minutes max. in above solvent at +60°C max.
3. Shower or Rinse Wash
5 minutes max. in above solvent at +60°C max.
(3) Condition
Soldering iron of +270±5°C shall be placed 0.5mm above
from electrode of resonator. Melting solder through
soldering iron shall be applied to electrode for 3±1
seconds, then being place in natural condition for 24 hour,
resonator shall be measured.
(2) Soldering Iron
Temperature (°C)
230
Pre-Heating
(in air)
Soldering Peak Temperature 240°C max.
30 sec. min. 60 sec. to 120 sec. 20 sec. max. 120 sec. min.
150
100
Gradual Cooling
(in air)
CSTCC (Except 2.00-3.49MHz)
CSTCV
CSACV
CSTCR
CSTCC (Only 2.00-3.49MHz)
CSTCW
CSACW
CSTCE
CSTCG
Series Wash
Available
Available
Available
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
∗All automotive types are Available.
MHz Chip Type Notice (Soldering and Mounting)
9
2
!Note
• Please read rating and !CAUTION (for storage and operating, rating, soldering and mounting, handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specification or transact the approval sheet for product specification before ordering.
Please read rating and !CAUTION (for storage and operating, rating, soldering and mounting, handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specification or to transact the approval sheet for product specificaion before ordering.
!Note
P16E14.pdf 02.7.9