Datasheet

1.47
37.3
2.000
50.80
1.00
25.4
0.100 MIN
@ 1-4, 8
FOR PIN
SHOULDERS
0.300
7.62
2.32
58.9
0.300
7.62
It is recommended that no parts be placed beneath converter (hatched area).
REF: DOSA Standard Specification
for Quarter-Brick DC/DC Converters
Recommended Footprint
(view through converter)
1
2
3
4
8
C
L
FINISHED HOLE SIZES
@ PINS 4 & 8
(PER IPC-D-275, LEVEL C)
0.070-0.084
(SEC)
C
L
(PRI)
C
L
TOP VIEW
FINISHED HOLE SIZES
@ PINS 1-3
(PER IPC-D-275, LEVEL C)
0.048-0.062
RECOMMENDED FOOTPRINT
Third Angle Projection
Dimensions are in inches (mm) shown for ref. only.
Tolerances (unless otherwise specified):
.XX ± 0.02 (0.5)
.XXX ± 0.010 (0.25)
Angles ± 2˚
I/O Connections (pin side view)
Pin Function Pin Function
1 +Vin 4 -Vout
2 Remote On/Off Control
3 -Vin 8 +Vout
UWQ-12/17-Q48 Series
Wide Input, Isolated DOSA Quarter Brick DC/DC Converters
MDC_UWQ-12/17-Q48 Series.A06 Page 11 of 17
www.murata-ps.com/support