Datasheet

www.murata-ps.com/support
MECHANICAL SPECIFICATIONS, THROUGH-HOLE MOUNT
ULT Series
Thirty-Second-Brick Isolated DC/DC Converters
with 2:1 Wide Input Range
MDC_ULT Series.F05 Page 18 of 26
INPUT/OUTPUT CONNECTIONS
Pin Function Pin Function
3 –Vin 4 –Vout
5 –Sense
2 On/Off Control 6 Trim
7 +Sense
1 +Vin 8 +Vout
Important! Always connect the sense pins. If they
are not connected to a remote load, wire each
sense pin to its respective voltage output at the
converter pins.
The 0.19-inch pin length is shown. Please refer to
the part number structure for alternate pin lengths.
Pin material: Brass.
Finish (all pins):
Gold (3-5 µ-inches min)
Over Nickel (50 µ-inches min)
Please note that some competitive units may use
different pin numbering or alternate outline views;
however, all units are plugin-compatible.
Third Angle Projection
Dimensions are in inches (mm) shown for ref. only.
Components are shown for reference only
and may vary between units.
Tolerances (unless otherwise specified):
.XX ± 0.02 (0.5)
.XXX ± 0.010 (0.25)
Angles ± 2˚
4.8
.19
.35
.010 MIN
CLEARANCE
8.9
1.02±0.05
.040±.002
@ PINS 1-3, 5-7
1.79±0.05
.071±.002
TYP SHOULDER
FOR 40 MIL PINS
GOLD (5μ"MIN) OVER NICKEL (50μ" MIN)
DIMENSIONS ARE IN INCHES [mm]
ANGLES: 1
COMPONENTS SHOWN ARE FOR REFERENCE ONLY
MATERIAL:
TOLERANCES:
2 PLACE .02
3 PLACE .010
.040 PINS: COPPER ALLOY
.060 PINS: COPPER ALLOY
3
4
8
FINISH: (ALL PINS)
6
2
1
5
7
BOTTOM VIEW
.600
13.64
15.24
3.0
.12
.150
3.81
3.81
.150
.300
7.62
.537
3.8
.15
.04 X 45°
CHAMFER
TOP VIEW
.75
19.1
23.4
.92
MTG PLANE
END
VIEW
1.52±0.05
.060±.002
@ PINS 4 & 8
#3
PIN
#4
PIN
PIN
#1
ISOMETRIC VIEW