Datasheet

UEI25 Series
Single Output Isolated 25-Watt DC/DC Converters
MDC_UEI25W.B09 Page 24 of 24
www.murata-ps.com/support
Murata Power Solutions, Inc. makes no representation that the use of its products in the circuits described herein, or the use of other
technical information contained herein, will not infringe upon existing or future patent rights. The descriptions contained herein do not imply
the granting of licenses to make, use, or sell equipment constructed in accordance therewith. Specifi cations are subject to change without
notice. © 2013 Murata Power Solutions, Inc.
Murata Power Solutions, Inc.
11 Cabot Boulevard, Mansfi eld, MA 02048-1151 U.S.A.
ISO 9001 and 14001 REGISTERED
This product is subject to the following operating requirements
and the Life and Safety Critical Application Sales Policy:
Refer to: http://www.murata-ps.com/requirements/
Through-hole Soldering Guidelines
Murata Power Solutions recommends the TH soldering specifi cations below when install-
ing these converters. These specifi cations vary depending on the solder type. Exceeding
these specifi cations may cause damage to the product. Your production environment may
differ; therefore please thoroughly review these guidelines with your process engineers.
Wave Solder Operations for through-hole mounted products (THMT)
For Sn/Ag/Cu based solders:
Maximum Preheat Temperature 115° C.
Maximum Pot Temperature 270° C.
Maximum Solder Dwell Time 7 seconds
For Sn/Pb based solders:
Maximum Preheat Temperature 105° C.
Maximum Pot Temperature 250° C.
Maximum Solder Dwell Time 6 seconds
SMT Refl ow Soldering Guidelines
The surface-mount refl ow solder profi le shown below is suitable for SAC305 type lead-
free solders. This graph should be used only as a guideline. Many other factors infl uence
the success of SMT refl ow soldering. Since your production environment may differ,
please thoroughly review these guidelines with your process engineers.