Datasheet

UEI25 Series
Single Output Isolated 25-Watt DC/DC Converters
MDC_UEI25W.B09 Page 2 of 24
www.murata-ps.com/support
PART NUMBER STRUCTURE
PERFORMANCE SPECIFICATIONS SUMMARY AND ORDERING GUIDE
➀ ➂
Root Models
Output Input
Effi ciency Package, C75
VOUT
(V)
IOUT
(A,
max)
Total
Power
(W)
R/N (mVp-p) Regulation (Max.)
VIN
Nom.
(V)
Range
(V)
IIN,
min.
load
(mA)
IIN,
full
load
(A)Typ. Max. Line Load Min. Typ. Case (inches) Case (mm) Pinout
UEI25-033-D48
3.3 7.5 25 50 80 ±0.1% ±0.2% 48 36-75 75 0.58 87.0% 89.5% 0.96x1.1x0.32 24.4x27.9x8.1 P85
UEI25-050-D48 5 5 25 50 80 ±0.1% ±0.2% 48 36-75 30 0.57 89.0% 91% 0.96x1.1x0.32 24.4x27.9x8.1 P85
UEI25-120-D48 12 2.1 25.2 95 120 ±0.1% ±0.1% 48 36-75 20 0.6 86.0% 87.5% 0.96x1.1x0.32 24.4x27.9x8.1 P85
Nominal Output Voltage
in Tenths of a Volt
Unipolar Output Isolated
25-Watt Series
UEI25 - D48-033 -
C
RoHS-6 Hazardous Substance Compliance
(Does not claim EU RoHS exemption 7b, lead in solder)
Input Voltage Range
D48 = 36-75 Vdc
MP
On/Off Control Logic:
P = Positive
N = Negative
Notes:
Please refer to the part number structure for additional options and complete order-
ing part numbers.
Ripple and Noise is shown at 20 MHz bandwidth.
All specifi cations are at nominal line voltage and full load, +25 °C. unless otherwise
noted. See detailed specifi cations for full conditions.
Output capacitors are 1 µF ceramic in parallel with 10 µF electrolytic. The input cap
is 4.7 µF ceramic, low ESR.
I/O caps are necessary for our test equipment and may not be needed for your ap-
plication.
Minimum load is 10% for rated specifi cations.
Lx
Pin Length Option (through-hole only)
Blank = Std. pin length 0.25˝ (6.3mm)
L1 = 0.110˝ (2.79mm)
L2 = 0.145˝ (3.68mm)
Surface Mount Option
Blank = Through-hole mount
M = Surface mount (MSL rating 2)
Special quantity order is required; samples available with standard pin length only.
SMT (M) versions not available in sample quantities.
Some model number combinations may not be available. See website or contact your local Murata sales representative.