Datasheet

www.murata-ps.com/support
UEE 150W Series
Isolated, High-Density, Eighth-Brick
DOSA Low Profi le DC-DC Converters
MDC_UEE 150W_Series.A02 Page 25 of 35
MECHANICAL SPECIFICATIONS, UEE-5/30-D48 AND UEE-12/12.5-D48 (THROUGH-HOLE MOUNT)
Third Angle Projection
Dimensions are in inches (mm shown for ref. only).
Components are shown for reference only
and may vary between units.
Tolerances (unless otherwise specified):
.XX ± 0.02 (0.5)
.XXX ± 0.010 (0.25)
Angles ± 2˚
2:APPLIED TORQUE PER SCREW SHOULD NOT EXCEED 5.3In-lb (0.6Nm).
4:ALL TOLERANCES: ×.××in ,±0.02in(×.×mm,±0.5mm)
×.×××in ,±0.01in(×.××mm,±0.25mm).
5:COMPONENTS WILL VARY BETWEEN MODELS.
6:STANDARD PIN LENGTH: 0.180 Inch
FOR L2 PIN LENGTH OPTION PLEASE REFER TO PART NUMBER STRUCTURE.
3:ALL DIMENSION ARE IN INCHES [MILLIMETERS].
UNLESS OTHERWISE SPECIFIED:
NOTES:
50.80
2.000
L
50.80
2.000
L
M3 No.4
M3 No.2
M3 No.1
M3 No.3
50.8
2.00
15.2 0.60
SEE NOTE 6
5
PIN SIDE VIEW
1
2
3
4
6
7
8
8
7
5
PIN SIDE VIEW
4
OPEN FRAME
15.24
0.600 15.24
2.30
58.4
0.600
7.62
0.300
22.9 0.90
φ0.062±0.001(1.575±0.025) highest component
between standoffs and
0.01 minimum clearance
PINS 1-3,5-7:
φ0.040±0.001(1.016±0.025)
PINS 4,8:
SEE NOTE 6
10.7
12.7
0.42 Max
2
3
1
6
2.30
0.300 15.24 0.600
7.62
0.600 15.24
22.9 0.90
WITH BASEPLATE OPTION
between standoffs and
highest component
0.01 minimum clearance
PINS 1-3,5-7:
φ0.040±0.001(1.016±0.025)
PINS 4,8:
φ0.062±0.001(1.575±0.025)
0.50 Max
1:For M3 THREAD HOLE No.1,No3;M3 SCREW USED TO BOLT UNIT'S BASEPLATE TO
OTHER SURFACES (SUCH AS HEATSINK) MUST NOT EXCEED 0.118''(3.0mm) DEPTH
BELOW THE SURFACE OF BASEPLATE; For SCREW HOLE No.2, No.4 NOT EXCEED 0.098"(2.5MM)
DOSA-Compatible
INPUT/OUTPUT CONNECTIONS
Pin Function
1 +Vin
2 On/Off Control
3 -Vin
4 -Vout
5 Sense (-)
6 Trim
7 Sense (+)
8 +Vout