Datasheet

www.murata-ps.com/support
UEE 150W Series
Isolated, High-Density, Eighth-Brick
DOSA Low Profi le DC-DC Converters
MDC_UEE 150W_Series.A02 Page 24 of 35
MECHANICAL SPECIFICATIONS, UEE-3.3/45-D48 (THROUGH-HOLE MOUNT)
Third Angle Projection
Dimensions are in inches (mm shown for ref. only).
Components are shown for reference only
and may vary between units.
Tolerances (unless otherwise specified):
.XX ± 0.02 (0.5)
.XXX ± 0.010 (0.25)
Angles ± 2˚
2.000
50.80
2.000
7.62
0.300
15.24 0.600
highest component
between standoffs and
0.012" minimum clearance
PINS 1-3,5-7:
φ0.040±0.001(1.016±0.025)
PINS 4,8:
φ0.062±0.001(1.575±0.025)
Max
0.42 10.7
4.57
0.180
7
1
8
15.24
0.600
0.600
15.24
7.62
0.300
0.90 22.9
58.4
2.30
6
2:APPLIED TORQUE PER SCREW SHOULD NOT EXCEED 5.3In-lb (0.6Nm).
4:ALL TOLERANCES: ×.××in ,±0.02in(×.×mm,±0.5mm)
×.×××in ,±0.01in(×.××mm,±0.25mm).
PIN SIDE VIEW
WITH BASEPLATE OPTION
OPEN FRAME
2
3
PIN SIDE VIEW
5:COMPONENTS WILL VARY BETWEEN MODELS.
6:STANDARD PIN LENGTH: 0.180 Inch
FOR L2 PIN LENGTH OPTION PLEASE REFER TO PART NUMBER STRUCTURE.
4
3:ALL DIMENSION ARE IN INCHES [MILLIMETERS].
5
BASEPLATE.
HEATSINK) MUST NOT EXCEED 0.118''(3.0mm) DEPTH BELOW THE SURFACE OF
1:M3 SCREW USED TO BOLT UNIT'S BASEPLATE TO OTHER SURFACES (SUCH AS
UNLESS OTHERWISE SPECIFIED:
NOTES:
between standoffs and
highest component
0.012 minimum clearance
PINS 1-3,5-7:
φ0.040±0.001(1.016±0.025)
PINS 4,8:
φ0.062±0.001(1.575±0.025)
Max
12.7 0.50
4.57
0.180
M3 TYP 2PL
2.000
50.80
15.24 0.600
3.81
3.81
0.150
0.150
22.9 0.90
58.4
2.30
DOSA-Compatible
INPUT/OUTPUT CONNECTIONS
Pin Function
1 +Vin
2 On/Off Control
3 -Vin
4 -Vout
5 Sense (-)
6 Trim
7 Sense (+)
8 +Vout