Datasheet

➀ Please refer to the part number structure for additional ordering information and options.
➁ All specifi cations are typical at nominal line voltage and full load, +25°C unless otherwise noted. See
detailed specifi cations. Output capacitors are 1 µF || 10 µF with a 22µf input capacitor. These caps are
necessary for our test equipment and may not be needed for your application.
ORDERING GUIDE ➀
Root Model ➀
Output Input
Effi ciency Dimensions (open frame)
V
OUT
(Volts)
I
OUT
(Amps,
max.)
Power
(Watts)
R/N (mV
pk-pk) Regulation (Max.) ➁
VIN Nom.
(Volts)
Range
(Volts)
IIN no
load (mA)
I
IN full
load
(Amps)Typ. Max. Line Load Min. Typ. (inches) (mm)
PAQ-29/5-D48-C
PAQ-29/5-D48-C 29.8 5 150 40 90 ±0.1% ±0.1% 48 36-75 85 3.36 91% 92.5%
2.3x1.45x0.46
2.3x1.45x0.46
58.4x36.8x11.7
58.4x36.8x11.7
PART NUMBER STRUCTURE
Pin length option
Blank = standard pin length 0.190 in. (4.8 mm)
L1 = 0.110 in. (2.79 mm)
*
L2 = 0.145 in. (3.68 mm)*
Lx
D48
Input Voltage Range
D48 = 36-75 Volts (48V nominal)
/
Nominal Output Voltage (29.8V)
29 5
Maximum Rated Output
Current in Amps
-
N
On/Off Control Logic
N = Negative logic
P = Positive logic
-
Baseplate Option
Blank = No baseplate, standard
B = Baseplate installed, optional
B
RoHS Hazardous Materials compliance
C = RoHS-6 (does not claim EU RoHS exemption 7b–lead in solder), standard
-
C
Complete Model Number Example:
Negative On/Off logic, baseplate installed, 0.110˝ pin length, RoHS-6 compliance
PAQ-29/5-D48NBL1-C
*Minimum order quantity is required.
Samples available with standard pin
length only.
Note:
Some model number combinations may
not be available. See website or contact
your local Murata sales representative.
PAQ
Power Amplifi er
Quarter-Brick
Baseplate Pin 3, see Mechanical Drawings (special order)*
Blank = No pin 3, standard
3 = Pin 3 installed, optional
3
PAQ Pin 3 Baseplate Connection
The PAQ module has an additional pin 3 on special order that connects to the baseplate but is
electrically isolated from the rest of the converter. Please refer to the mechanical drawings.
Pin 3 offers a positive method of controlling the electrical potential of the baseplate, indepen-
dent of the converter.
The baseplate may be ordered by adding a “B” to the model number tree and pin 3 will be pre-
installed by adding a “3.” The two options are separate. Please refer to the Ordering Guide. Do
not order pin 3 without the baseplate. Note that “pin 3” converters may be on limited forecast,
requiring minimum order quantities and scheduled deliveries.
PAQ Series
Up to 150W 29.8V Nom Output Quarter-Brick Isolated
DC-DC Converter with 2:1 Wide Input Range
MDC_PAQ Series.A02 Page 2 of 16
www.murata-ps.com/support