Datasheet

ManualsBrandsMURATA POWER SOLUTIONS ManualsPSU ComponentsDC/DC converter (print) 29.8 V 3.3 A 100 W No. of outputs: 1 x

➀ Please refer to the part number structure for additional ordering information and options.

➁ All speciﬁ cations are typical at nominal line voltage and full load, +25°C unless otherwise noted. See

detailed speciﬁ cations. Output capacitors are 1 µF || 10 µF with a 22µf input capacitor. These caps are

necessary for our test equipment and may not be needed for your application.

ORDERING GUIDE ➀

Root Model ➀

Output Input

Efﬁ ciency Dimensions (open frame)

OUT

(Volts)

OUT

(Amps,

max.)

Power

(Watts)

R/N (mV

pk-pk) Regulation (Max.) ➁

VIN Nom.

(Volts)

Range

(Volts)

IIN no

load (mA)

IN full

load

(Amps)Typ. Max. Line Load Min. Typ. (inches) (mm)

PAE-29/3-D48

PAE-29/3-D48 29.8 3.3 98.34 65 100 ±0.1% ±0.1% 48 36-75 12 2.21 91% 92.5%

2.3 x 0.90 x 0.44

58.4 x 22.9 x 11.1

PART NUMBER STRUCTURE

Pin length option

Blank = standard pin length 0.188 in. (4.78 mm)

L1 = 0.110 in. (2.79 mm)➀

L2 = 0.145 in. (3.68 mm)➀

D48

Input Voltage Range

D48 = 36-75 Volts (48V nominal)

Nominal Output Voltage (29.8V)

Maximum Rated Output

Current in Amps(3.3A)

On/Off Control Logic

N = Negative logic

P = Positive logic

Baseplate Option

Blank = No baseplate

B = Baseplate installed

RoHS Hazardous Materials compliance

C = RoHS-6 (does not claim EU RoHS exemption 7b–lead in solder), standard

Complete Model Number Example:

Negative On/Off logic, baseplate installed, 0.110˝ pin length, RoHS-6 compliance

PAE-29/3-D48NBL1-C

PAE

Power Ampliﬁ er

Eighth-Brick

Baseplate Pin 3, see Mechanical Drawings (special order) ➀

Blank = No pin 3, standard

3 = Pin 3 installed, optional

PAE Pin 3 Baseplate Connection

The PAE module has an additional pin 3 on special order that connects to the baseplate but is

electrically isolated from the rest of the converter. Please refer to the mechanical drawings.

Pin 3 offers a positive method of controlling the electrical potential of the baseplate, indepen-

dent of the converter.

The baseplate may be ordered by adding a “B” to the model number tree and pin 3 will be pre-

installed by adding a “3.” The two options are separate. Please refer to the Ordering Guide. Do

not order pin 3 without the baseplate. Note that “pin 3” converters may be on limited forecast,

requiring minimum order quantities and scheduled deliveries.

➀ Special quantity order is required; samples available with standard pin length only.

➁ Some model number combinations may not be available. See website or contact your local Murata sales representative.

PAE Series

Up to 100W 29.8V Nom Output Eighth-Brick Isolated

DC-DC Converter with 2:1 Wide Input Range

MDC_PAE Series.A01 Page 2 of 17