Datasheet

RECOMMENDED LAYOUT
Third Angle Projection
Dimensions are in inches (mm shown for ref. only).
Components are shown for reference only.
Tolerances (unless otherwise specified):
.XX ± 0.02 (0.5)
.XXX ± 0.010 (0.25)
Angles ± 1˚
SOLDER PAD NOTES:
[1] To avoid incorrect contacts with exposed vias and plated through holes on the bottom of the
converter, do not have any exposed copper in the center area of the host PC board (see drawing).
Except for connections to the pads, keep all external circuits away from the board edges.
[2] Do not connect any additional components between the Trim pin and Vout or between the Trim
and Sense pins. Use only the specified connections.
TOP VIEW
5.46
1.22
6.09
7.54 4.83 4.83 4.82 4.83 4.95
13.46
1.52
5.21
5.46
1.90
Product outline
(B) (B)
(B)
(B)
(B)
(B)
(B)
1
8
2
9
10
76543
(B)
(A)
(A)
2 PLACES
8 PLACES
Unit:mm
OKL2-T/20-W12 Series
Programmable Output 20-Amp iLGA SMT PoL
DC-DC Converter Series
MDC_OKL2-T20-W12.B02 Page 13 of 19
www.murata-ps.com/support