Datasheet

Soldering Guidelines
Murata Power Solutions recommends the specifi cations below when installing these
converters. These specifi cations vary depending on the solder type. Exceeding these
specifi cations may cause damage to the product. Your production environment may differ
therefore please thoroughly review these guidelines with your process engineers.
Recommended Lead-free Solder Refl ow Profi le
0
50
100
150
200
250
0 30 60 90 120 150 180 210 240 270 300
Time (sec)
Temperature (°C)
Preheating Zone
240 sec max
Soaking Zone
120 sec max
Reflow Zone
time above
217° C
45-75 sec
Peak Temp.
235-260° C
<1.5° C/sec
High trace = normal upper limit
Low trace = normal lower limit
Reflow Solder Operations for surface-mount products (SMT)
For Sn/Ag/Cu based solders:
Preheat Temperature Less than 1 ºC. per second
Time over Liquidus 45 to 75 seconds
Maximum Peak Temperature 260 ºC.
Cooling Rate Less than 3 ºC. per second
For Sn/Pb based solders:
Preheat Temperature Less than 1 ºC. per second
Time over Liquidus 60 to 75 seconds
Maximum Peak Temperature 235 ºC.
Cooling Rate Less than 3 ºC. per second
Voltage Range Graph
Please observe the limits below for voltage input and output ranges. These
limits apply at all output currents.
0.5 1 1.5 2 2.5 3 3.5 4 4.5 5 5.5
Output Voltage (V)
0
2
4
6
8
10
12
14
16
Input Voltage (V)
Upper Limit
Lower Limit
Vin=14V / Vout=1V
Vin=4.5V / Vout=3.63V
OKL-T/6-W12 Series
Programmable Output 6-Amp iLGA SMT PoLs
MDC_OKL-T/6-W12 Series.C02 Page 16 of 17
www.murata-ps.com/support