Datasheet

MECHANICAL SPECIFICATIONS
INPUT/OUTPUT CONNECTIONS
Pin Function
1 On/Off Control*
2 VIN
3 Sequence/Tracking
4 Ground
5 Trim
6 VOUT
7 +Sense (VOUT)
8 -Sense (Ground)
9 N.C.
10 N.C.
*The Remote On/Off can be provided with
either positive (P suffi x) or negative (N suffi x)
logic.
Third Angle Projection
Dimensions are in inches (mm shown for ref. only).
Components are shown for reference only.
Tolerances (unless otherwise specified):
.XX ± 0.02 (0.5)
.XXX ± 0.010 (0.25)
Angles ± 1˚
SIDE VIEW
TOP VIEW
SOLDER PAD NOTES:
[1] To avoid incorrect contacts with exposed vias and plated through holes on the bottom of the
converter, do not have any exposed copper in the center area of the host PCboard (see drawing).
Except for connections to the pads, keep all external circuits away from the board edges.
[2] Do not connect any additional components between the Trim pin and Vout or between the Trim
and Sense pins. Use only the specified connections.
8.55max
BOTTOM VIEW
UNIT[mm]
2.44×1.73×10PLACES
45
6
7
8
1
9
3
10
2
0
Y
X
11.43
10.16
5.72
1.27
1.52 6.35
10.41 14.48 19.05 20.32
18.80
[Tolerances ±0.25mm]
OKL2-T/12-W5 Series
Programmable Output 12-Amp iLGA SMT PoL
DC-DC Converter Series
MDC_OKL2-T/12-W5.B02 Page 10 of 17
www.murata-ps.com/support
Figure 3. OKL2-T/12-W5 Mechanical Outline