Datasheet

Soldering Information - Hole Mounting

The hole mounted product is intended for plated through hole mount-

ing by wave or manual soldering. The pin temperature is speciﬁ ed to

maximum to 270°C for maximum 10 seconds.

A maximum preheat rate of 4°C/s and maximum preheat tempera-

ture of 150°C is suggested. When soldering by hand, care should be

taken to avoid direct contact between the hot soldering iron tip and

the pins for more than a few seconds in order to prevent overheating.

A no-clean ﬂ ux is recommended to avoid entrapment of cleaning

ﬂ uids in cavities inside the product or between the product and the

host board. The cleaning residues may affect long time reliability and

isolation voltage.

Delivery Package Information

The products are delivered in antistatic carrier tape (EIA 481

standard).

Carrier Tape Specifications

Material Antistatic PS

Surface resistance <10

Ohm/square

Bakeability The tape is not bakable

Tape width, W 56 mm [2.20 inch]

Pocket pitch, P

32 mm [1.26 inch]

Pocket depth, K

13 mm [0.51 inch]

Reel diameter 381 mm [15 inch]

Reel capacity 130 products /reel

Reel weight 1.8 kg/full reel

OKDx-T/50-W12-C

50A Digital PoL DC-DC Converter Series

MDC_OKDx-T/50-W12-C.A04 Page 40 of 41