Datasheet

LXDC2UR series
Micro DC-DC converter
24
Dec 2014
5. Cleaning Conditions:
The product is not designed to be cleaned after soldering.
6. Operational Environment Conditions:
Products are designed to work for electronic products under normal environmental conditions (ambient
temperature, humidity and pressure). Therefore, products have no problems to be used under the similar
conditions to the above-mentioned. However, if products are used under the following circumstances, it
may damage products and leakage of electricity and abnormal temperature may occur.
- In an atmosphere containing corrosive gas ( Cl
2,
NH
3,
SO
x,
NO
x
etc.).
- In an atmosphere containing combustible and volatile gases.
- In a dusty environment.
- Direct sunlight
- Water splashing place.
- Humid place where water condenses.
- In a freezing environment.
If there are possibilities for products to be used under the preceding clause, consult with Murata before
actual use.
If static electricity is added to this product, degradation and destruction may be produced.
Please use it after consideration enough so that neither static electricity nor excess voltage is added at the
time of an assembly and measurement.
If product malfunctions may result in serious damage, including that to human life, sufficient fail-safe
measures must be taken, including the following:
(1) Installation of protection circuits or other protective device to improve system safety
(2) Installation of redundant circuits in the case of single-circuit failure
7. Input Voltage and Output Current limitation:
Products shall be used in the input power capacity as specified in this specifications.
Inform Murata beforehand, in case that the components are used beyond such input power capacity range .