Datasheet

LXDC2HL series
Micro DC-DC converter
11
Dec 2014
10. Measurement Data
Micro DC-DC Converter evaluation board (P2LX0244)
Measurement setup
The enable switch has three positions.
1. When it is toggled to “ON” side, the device starts operation.
2. When it is toggled to “OFF” side, the device stops operation and remains in shut down status.
3. When it is set to middle of “ON” and “OFF”, the EN pin floats and an external voltage can be applied to the
EN terminal pin on the EVB. If you don’t apply an external voltage to EN pin, the enable switch should not to
be set to the middle position.