Datasheet

LXDC2HL series
Micro DC-DC converter
28
Dec 2014
4. Soldering Conditions:
Soldering is allowed up through 2 times.
Carefully perform preheating ：△T less than 130 °C.
When products are immersed in solvent after mounting, pay special attention to maintain the temperature
difference within 100 °C. Soldering must be carried out by the above mentioned conditions to prevent
products from damage. Contact Murata before use if concerning other soldering conditions.
Use rosin type flux or weakly active flux with a chlorine content of 0.2 wt % or less.
Reflow soldering standard conditions (example)