Installation Manual Wind Sensor Installation Installation Instructions Ag/MIS/ImGb-2797-03/21 Rev 1.
Wind Sensor Installation Installation Manual Revision: N1.0 of 03.2021 Product Software: N/A This manual for use and maintenance is an integral part of the apparatus together with the attached technical documentation. This document is destined for the user of the apparatus: it may not be reproduced in whole or in part, committed to computer memory as a file or delivered to third parties without the prior authorization of the assembler of the system.
Index Chapter 1 page INTRODUCTION ------------------------------------------------------------------------------------------------------------------------------------------ 4 1.1 1.2 1.
1 Introduction 1.1 Disclaimer Munters reserves the right to make alterations to specifications, quantities, dimensions etc. for production or other reasons, subsequent to publication. The information contained herein has been prepared by qualified experts within Munters. While we believe the information is accurate and complete, we make no warranty or representation for any particular purposes.
2 Installation © Munters AB, 2021 5
© Munters AB, 2021 6
© Munters AB, 2021 7
© Munters AB, 2021 8
© Munters AB, 2021 9
© Munters AB, 2021 10
© Munters AB, 2021 11
© Munters AB, 2021 12
© Munters AB, 2021 13
© Munters AB, 2021 14
3 Wiring © Munters AB, 2021 15
4 Specifications General Sensor Type Wind Speed Wind Cups and Magnetic Switch Wind Direction. Wind Vane and Potentiometer Attached Cable Length… 40 Feet (12 m) Maximum Cable Length 330 Feet (100 m) Cable Type 4-Conductor, 26 AWG Connector Modular Connector (RJ-11) Material Wind Vane and Control Head. UV-Resistant ABS Wind Cups Polycarbonate Anemometer Arm Anodized Aluminum Dimensions 18. 5" Long x 7.5" High x 4.75" Wide (89mm x 83mm x 38mm) Weight 2lbs 15oz (1.
5 Warranty Warranty and technical assistance Munters products are designed and built to provide reliable and satisfactory performance but cannot be guaranteed free of faults; although they are reliable products they can develop unforeseeable defects and the user must take this into account and arrange adequate emergency or alarm systems if failure to operate could cause damage to the articles for which the Munters plant was required: if this is not done, the user is fully responsible for the damage which th
The liability of the manufacturer Munters ceases in the event of: • • • • dismantling the safety devices; use of unauthorised materials; inadequate maintenance; use of non-original spare parts and accessories. Barring specific contractual terms, the following are directly at the user’s expense: • • • • • preparing installation sites; providing an electricity supply (including the protective equipotential bonding (PE) conductor, in accordance with CEI EN 60204-1, paragraph 8.
Australia Munters Pty Limited, Phone +61 2 8843 1594, Brazil Munters Brasil Industria e Comercio Ltda, Phone +55 41 3317 5050, Canada Munters Corporation Lansing, Phone +1 517 676 7070, China Munters Air Treatment Equipment (Beijing) Co. Ltd, Phone +86 10 80 481 121, Denmark Munters A/S, Phone +45 9862 3311, India Munters India, Phone +91 20 3052 2520, Indonesia Munters, Phone +62 818 739 235, Israel Munters Israel Phone +972-3-920-6200, Italy Munters Italy S.p.A.
