User`s manual

No gap is allowed

(Fig.6)

At body

At panel

At body

At panel

( Fig.7 )

2. If gap is still left between the celling and the panel after screwing the screws,readjust height of the indoor unit body

(Refer to Fig.6)

Indoor unit installation

* After fixing,be sure no gap left between the ceiling and the panel

3.Wiring of the decoration panel.

 Connect te joints for swing flap motor lead wire(at 2 places) installed on the panel (Refer to Fig.7)

Adjustment of the indoor unit body from the

holes in the corner of the panel is possible if

the indoor unit is kept leveled and the

drainage pipe piping etc is unaffectecd.

Indoor unit installation