User Manual

(2) Right-click the pos file and select show profile, Click on the lower right corner, Enter
password, modify permissions to read and write.
Note: if the above two methods are successful, "2. Input command" will be carried out. If not,
the terminal prompt message will be checked.
2. Select the corresponding PPD file,insert the printer into the MAC, select the corresponding
PPD file for the corresponding model: if it is 80 model, usb will recognize it as 80 model,
and then open system preferences > printer - > add printer - > select other > use the
corresponding PPD file - > click repair - > to complete installation.
3. Select the document for printing test.
Welcome to watch training video of Mac driver installment on YouTube:
Mac driver download link:
https://youtu.be/I9cmEOTkHIo
http://bit.ly/MacDriverDowload
Instructions on Printer TEST V3.1C Testing tools
I. Introduction of Main Interface
1.Communication port selection:
Four options of printer communication interface: parallel port, serial port, USB port and Ethernet port.
2.Printer type selection:
Printer type: default to POS-80
3.Parallel port Settings (LPT Set):
Parallel port Settings ---be consistent with the computer communication parallel port number.
4.Serial port Settings (COM Set):
Serial port Settings --- set the serial port number, baud rate, flow control, etc.
5.Ethernet port Settings (NET Set):
Change the IP address of Ethernet port printer through Ethernet port Settings.