User Manual

Instruction input introduction：
S1：OPEN the V3.1C tool as shown below：
S2： When sending data in hexadecimal format,please display it as shown below:
S3:Enter the print data in hexadecimal format and press the “Print” button to complete the
data entry and transmission.
Take the sound and light alarm function switch operation instructions as an example:
① Cutter with alarm on/off：1F 1B 1F E0 13 14 m 04 02 03
S1：OPEN the V3.1C tool as shown below
S2：Select the corresponding interface .If the serial port needs to set the baudrate,the printer
baudrate can be obtained by printing the selftest.The network port needs to set the IP address.
For the operation mode,refer to the following network IP setting instructions.After the setting is
completed,click the “Connect” button( ),and the connection success prompt indicates that
the network connection is successful.Select the area of the interface as shown below:
S3:Check the “HEX” option box( ) and click the “Clear” button( )to clear the contents of
text input box.The result is shown below:
S4:If you need to turn on the “cutting with alarm” function,enter the command as shown in the
text box and click the “Print” button( )to send it.
Conversely,if you want to turn off the“cutting with alarm” function,enter the command as
shown in the text box and click the “Print” button( ) to send it.
②Cutter idle alarm on/ off：1F 1B 1F A0 mode 00 0A 00 FF
The operation is the same as ①
1 Font size
GS !
[Name] Select character size
[Format] ASCII code GS ! n
Hexadecimal code 1D 21 n
Decimal code 29 33 n
[Range] 0 ≤ n ≤ 7， ,16 ≤ n ≤ 23，32 ≤ n ≤ 39，48 ≤ n ≤ 55，
64 ≤ n ≤ 71， 80 ≤ n ≤ 87， ,96 ≤ n ≤ 103, 112 ≤ n ≤ 119
1 ≤ Vertical magnification ≤ 8， 1 ≤ Horizontal magnification ≤ 8
[Description] Use the 0th to 2nd digits to select the character height,4 to 6 digits to select the
character width, and 3,7 digits to be 0,which is 0XXX0XXX.