User Manual

11.“ Network Settings”
It includes “Network Settings” and “Bluetooth Settings”
(Network Settings)
11.1 Set up the Printer’s IP address.
11.2 Set up the Subnet Mask.
11.3 Set up the Gateway.
11.4 WIFI SSID address settings. Note: the SSID address is the name of your Wireless Router ’s name.
For example, if the address of the current Router (SSID) is: Pinter001, then this SSID address
should be typed in the tab of “SSID”.
11.5 WIFI password settings. Note: the password of the Wireless Router
For example, if the WIFI’s
current password is:123456789, then this password should be typed in the tab of “WIFI password”.
11.6 Encryption type of WIFI SSID settings. Note: the encryption type of the Wireless Router.
For example, if the encryption type of the Router (SSID) is: WPA_TKIP_AES_PSK, then this
information should be selected in the tab of “SSID Encryption type”.
11.7 After filling the above information, click the “Setting All” option. The printer will “BEEP”.
Next, restart the printer.
(Bluetooth Settings)
11.7.1 Set up the Port name of the Bluetooth Printer (the Factory Default BT NAME is “Printer001”)
11.7.2 Set up the Password of the Bluetooth Printer (the Factory Default BT PINKEY is “123456”)
11.7.3 After finishing the above settings, click “Setting”, and then finished the settings of Bluetooth
printerParameters.
12.“USB Mode Setting”
Mode Setting of printer’s USB port includes Usb Printing and Virtual Com. USB mode switches
accordingto customer demand. For specific operation, refer to file “instructions of switching
between USB port andvirtual Com "in the folder “IP address change and other functional
specification”
13.“Black mark Settings”
To set special paper printing with black mark.
13.1 Offset in paper-feed direction, offset in paper unwinding direction
To set the direction of data calculation for paper cutting position, the default value is feed direction.
13.2 “Please enter the black mark spacing (mark length)” To calculate the center distance of two
black marks.
13.3 “Set the black mark Maximum width”
It’s a value to calculate the actual height of a black mark.
13.4 “the offset of paper cutting position relative to the black mark position”
It’s to calculate the actual distance from the paper detector in the print head to the paper cutter.
13.5 “Distance between the print starting position and paper cutting position”
It’s to calculate the distance from the print starting position to paper cutting position.
13.6 “Print a ticket test”
Click this button and a note will be printed out. If it’s properly set, paper will automatically go a
length of black mark and then be cut.
13.7 “feed to next print position”
Click this button and paper will go to the next print starting position for a blace marker. Print out
the information to test the right position.
13.8 “feed to the next cutting position”
Click this button and paper will go to the next paper cutting position and paper will be cut to test
the accuracy of paper cutting position.
13.9 Turn on the black mark, turn off the black mark
Black mark function is off by default. Turn on black mark function to make related Settings. In case
black mark position is detected incorrect, please reset referring to 7 “P80 black mark sensitivity”
of “advanced”.
14.“Send file data”
Click button,choose and open TXT format file in the pop-up dialog box, and then the printer will print the
contents of the file.
15.“Cut With Beep”
The alarm function can be set to turn on or off after cutting paper with cutter.
16.“Input BOX Code Page”
Words responsible for decoding text boxes.