User Guide

6. Change the "Obtain an IP address automatically" from "Enable" to "Disable",
And write the new IP into “IP Address”
Notes: printer’s IP address shall be in the same network segment as the connected
computer’s to realize intercommunication, And it can't conflict with the IP address of
other devices.
Subnet Mask/Gateway Address must be the same as your PC
( [Start]--[Run]--[cmd] run the cmd command:ipconfig)
7. Click save after every setting
8. AP mode setting
(Change the WIFI name and password of the printer, optional operation)
No need change the IP address here.
Click save
9. After save successfully, click” Restart” or Switch printer power on again.