Instructions for Use

Page5 of 21
ITPP047 Thermal Printer Hardware Manual
Version 1.00
1.2. Find a Proper Place for Printer
Before unpacking the printer, you need to take a few minutes to think about.
where you plan to place it. Remember the following points when using our printer to ensure the security.
1. Choose a firm, level surface where the printer will not be exposed to vibration.
2. The power outlet you plan to connect to for power should be nearby and unobstructed.
3. Make sure that the printer is close enough to your host computer for you to connect
the two.
4. Make sure that the printer is not exposed to direct sunlight.
5. Make sure that the printer is well away from heaters and other sources of extreme
heat.
6. Make sure that the surrounding area is clean, dry, and free of dust.
7. Make sure that the printer is connected to a reliable power outlet. It should not be on
the same electric circuit as copiers, refrigerators, or other appliances that cause power
spikes.
8. Make sure that the room where you are using the printer is not too humid.
9. This device employs a DC motor and switches that have an electrical contact point.
Avoid using the device in environments where silicon gas can become volatile.
CAUTION：
1. Shut down your equipment immediately if it produces smoke, a strange odor, or unusual noise.
Immediately unplug the equipment and contact your dealer for advice.
2. Never attempt to repair this product yourself. Improper repair work can be dangerous.
3. Never disassemble or modify this product. Tampering with this product may result injury, fire, or
electric shock.