Safety Information

Page
37
of
41
ITPP047 Thermal Printer Software Manual
Version 0.10
A: Set Net(WIFI Settings):
a) Set up the Printer’s IP address.
b) Set up the Subnet Mask.
c) Set up the Gateway.
d) WIFI SSID address settings. Note: the SSID address is the name of your Wireless Router’s name.
e) WIFI password settings. Note: the password of the Wireless Router
f) Encryption type of WIFI SSID settings. Note: the encryption type of the Wireless Router. For example,
if the encryption type of the Router (SSID) is: WPA_TKIP_AES_PSK, then this information should be
selected in the tab of "SSID Encryption type".
g) After filling the above information, click the "Setting All" option. The printer will "BEEP". Next,
restart the printer.
B:BluetoothSet:
a). Set up the Port name of the Bluetooth Printer (the Factory Default BT NAME is "Printer001")
b) Set up the Password of the Bluetooth Printer (the Factory Default BT PINKEY is "123456")
c) After finishing the above settings, click "Setting", and then finished the settings of Bluetooth printer
Parameters.