Safety Information

Page
34
of
41
ITPP047 Thermal Printer Software Manual
Version 0.10
7.0.Configuration
7.1. For Windows:
7.1.1."Printer Test V5.0"
7.1.1.1. Introduction of Main Interface
Tips: The numbers in the picture correspond to the points
1.Communication port selection: parallel port, serial port, USB port and Ethernet port.
2.Printer type: default is POS-80
3.Parallel port Settings (LPT Set): Parallel port Settings ---be consistent with the computer
communication parallel port number.
4.Serial port Settings (COM Set): Serial port Settings --- set the serial port number, baud rate, flow
control, etc.
5.Ethernet port Settings (NET Set):
Change the IP address of Ethernet port printer through Ethernet port Settings.
"Local IP"--- computer’s local IP address which can be added automatically or by clicking "refresh" button.
"Printer IP"---printer’s current IP address , its detailed information can be seen on self- test page, only
suitable for Ethernet port printers.
"New IP address"--- set the new IP address
Notes: printer’s IP address shall be in the same network segment as the connected computer’s to realize
intercommunication, And it can't conflict with the IP address of other devices.