User Manual

4.3 Counting Function Options
Page 13 Page 14
4.2.4 Non-Volatile Memory for Currency Mode
4.3.1 Automatic Banknote Counting
4.3.2 SN Reading
4.3.3 Batch Setting
Example: Put a handful of banknotes (including USD, EUR, CAD, MXN) into the
IMC01 hopper to count. The interface of the IMC01 displays as Figure 4-15 at the end
of counting.
The currency mode setting is non-volatile. For example, if you set multi-currency
counting mode before power down the IMC01, next time the IMC01 is in
multi-currency counting mode after power on. It is very convenient that you don’t
need to reselect the currency every time you power on the IMC01.
The key is used to enable or disable the SN reading function in the main
interface. The default setting of SN reading is on. Every time the IMC01 resets,
the setting is reset to be on state.
Press the key to select the batch number in the banknote counting inter-
face, the screen display is shown in Figure 4-17. By pressing the key of the
control panel, the batch number will be cyclically switched according to
100-50-0 sequence.
Press the key to enable or disable the automatic banknote counting in the
main interface.
The default setting of automatic counting is on. Every time the IMC01 resets, the
setting will be reset to be on state.
As shown in Figure 4-16, pressing the key is needed every time when you put
banknotes in the hopper to start counting.
IMC01 Banknote Counter User Manual Version 1.09 IMC01 Banknote Counter User Manual Version 1.09
Figure 4-15 Multi-currency MDC Counting Result
Figure 4-16 Auto Banknote Detecting Off
Figure 4-17 Batch Setting Interface