User Manual

Page 19 Page 20
IMC01 Banknote Counter User Manual Version 1.09 IMC01 Banknote Counter User Manual Version 1.09
4.6.2 Data transfer to PC
4.7 CFD Level
Figure 4-25 The serial port tool settings
Figure 4-26 The serial port tool settings
(1)Use the DB9 serial cable to connect the IMC01 to the computer, then turn on
the computer.
(2)Open the serial port tool (such as RS232 Hex Com Tool), select the serial port
corresponding to the IMC01, and set the baud rate to 9600, as shown in the
figure below.
(3)Click the "PRINT" button of IMC01, and then click the "RESTART" button, IMC01
will transmit the data to the serial port tool, as shown in the figure below.
This is a tutorial video link for transferring IMC01 data to a computer:
http://munbyn.biz/DatatransfertoPC
The data is transmitted to the computer for display through the DB9 serial cable.
There are 3 adjustable CFD levels. By pressing the key, the CFD level graphic
appearing in the upper right corner will change.
Note: CFD level 0, means no counterfeit detection, the most strictly detection is
level 3.
4.8 Face Function
To turn on the Face Function by long pressing the key until a beep sound,
as shown in the following figure.
Note: After turning on the "Face" function, the banknote counter will automati-
cally stop and alarm when it detects that the face of the banknote is different
from the previous banknote.
Figure 4-27 CFD Level
Figure 4 -28 Face Function