Instruction manual

REMOTE CONTROL
Before making any connections to the SB-3866. Observe the following:
Ensure the mains voltage supply matches the label on the supplied plug- Pack (+/- 10%)
Ensure that the power switch is OFF
Ensure that all system grounds (earth) are connected to a common point.
Avoid powering equipment within a system from multiple power sources that may be separated by large distances
Connect all audio video sources and destination equipment
Power up all source and destination audio-visual sources
For each destination output select the appropriate input source by using The front panel input select buttons. The supplied IR remote
control. Or through the RS-232 serial communications port.
Upon power up the switcher will return to its last used setting before Powered down.
REMOTE CONTROL
1. SWITCH POWER ON or OFF:
Controller with a power ON and OFF
2. INPUT 1 To 8 SOURCES SELECT:
The Input 1 to 8 Audio and Video source selections.
Input- # 1 Composite Video / Stereo Audio
Input- # 2 Composite Video / Stereo Audio
Input- # 3 S-Video / Stereo Audio
Input- # 4 S-Video / Stereo Audio
Input- # 5 Component Video (YPbPR) / Stereo Audio
Input- # 6 Component Video (YPbPR) / Stereo Audio
Input- # 7 VGA-RGBHV / Stereo Audio
Input- # 8 VGA-RGBHV / Stereo Audio
3. SELECT VGA OUTPUT RESOLUTIONS:
Select VGA output resolutions as following :
- SXGA 1280 x 1024
- WXGA 1366 x 768
- WSXGA+1680 x 1050
- WUXGA 1920 x 1200
4. MENU - OSD:
OSD to setup or Adjust output resolutions and color.
5. EXIT - OSD:
OSD to EXIT
6. AUDIO VALUE ADJUSTMENT:
OSD to setup or Adjust Audio output Volume.
5