Instruction manual

OSD SETUP VGA OUTPUT RESOLUTIONS & VIDEO SOURCES SELECTIONS
CONTENT
9
Resolution
Adjustment
Changes the output resolution
to one of the pre-set values.
Note that after you make this
change,your display device
might need to re-clock to the
signal. You can do this by
changing your source input
and then back again to the
SB-3866 input.
For example:
If you have the SB-3866
connected to the VGA input
on your projector. After you
change resolution,you need
to set the projector to switch
to video input and then
change back to VGA.
Input Source
Changes the Input Signal
Source to one of pre-set
values. The front panel LED
will also display the Input
Signal Source selected.
As product improvements
continues, specifi cations and
procedures are subject to
change and without notice.