Datasheet

Product Information TURBiO
Technical Data :
Operating voltage :
Preheat time :
Pulse height :
Safety shutdown :
Lamp types :
Temperature range :
Approvals:
200 - 260 V AC 50/60 Hz
0.3 seconds nominal @ 20°C
1500 V maximum
Within 1.0 seconds @ 20°C
4-125W Linear T5/T8/T12
10-38W 2D (TC-DD)
5-11W PLS (TC)
10-26W PLC (TC-D)
18-36W PLL (TC-L)
20-60W Circular- and U-Tube (T-R, T-U)
Operating : - 5 to + 75°C
Storage : - 50 to + 105°C
-find more details and actual lamp list
under www.palmstep.com
Electronic starter for fast starting of 4-125W single inductive fluorescent lamp circuits.
The TURBiO electronic starter uses a DC pre-heat system to quickly heat the lamp cathodes
to working temperature, before applying a controlled voltage pulse to successfully strike
lamps in extremely low ambient temperatures. This method of ignition prevents cathode
damage and significantly lengthens lamp life. Additionally, a safety monitoring system shuts
down the system in the event of a fault and prevents dangerous overheating and the annoying
flashing associated with glow type starters. R ircuit methods allow us to provide a 10
year no quibble guarantee for this product, which has a proven design life exceeding 20
years.
Housed in a two-pin canister with dimensions to IEC155, for the direct replacement of glow
starters without circuit modification.
efined c
We reserve the right to alter details and specifications without prior notice. Ó PALM STEP ELECTRONICS Ltd 1999.
Dimensions & materials :
All dimensions in millimetres
39
12.721
IMPORTANT NOTE : Due to the boosted pre-heating mode, for lamps larger than 30W rating,
with some types of luminaire, ballast "buzz" during starting may be annoying. Use ÖKO6 if this is
the case. Lamps of 30 W or smaller do not normally exhibit starting noise.
Inductive Circuit
St
C
L
N
Canister: Polycarbonate, translucent red
Printing: Gold
Base: Polycarbonate
Pins: Nickel plated brass
10
VDE
Version 28.06.2000