Technical Manual

TLA 852/FLA 872
TM1205 Issue 2 Page 2 - 7
When the alarm is set to ON and the alarm time is reached, the standby screen will
show a flashing alarm symbol and the alert will operate for eight seconds. To stop
the alert within the eight second period, push any button.
To set the alarm time, set the alarm to ON. The display shows the alarm symbol and
also shows the time the alarm is set to sound.
To change the time:
a) Push the O> button and the hour numbers flash. Use the ¬ or - buttons to
set the required hour.
b) Push the O> button again and the tens of minutes number flashes. Set the
required figure with the ¬ or - buttons, then push the O> button to make the
minutes number flash. Set the required figure with the ¬ or - buttons.
c) To return to the standby screen, push and hold the O> button for one second
or wait for the unit to time-out. The screen now shows the alarm symbol to
indicate that the alarm is set.
2.2.6 Alert
The alert can be set to one of nine options; seven audible, vibrate or ‘no alert’.
To set the alert, first select the alert function on the option screen as shown in
paragraph 2.2.3
a) When the alert screen shows, use the ¬ or - buttons to select an alert (as
each alert is selected, the associated tone sounds or the vibrate operates. To
stop the alert, push any button).
b) When the required alert is selected, push the O> button for one second or wait
for the unit to timeout.
c) The display returns to the standby screen and shows the alert symbol.
If the vibrate alert is selected, the display shows
When the audible alert is selected, the display shows
When ‘no alert’ is selected, the display shows
The alert can be quickly set ON or OFF from the standby screen by pushing and
holding the O> button for three seconds.