User's Manual

155 mm
TAG 10821-1
TM 1184 Issue 1 AL1 (May 1997) Page A1 - 7
Figure 2: Wall Mounting Template
INSTALLATION PROCEDURE
Wall Mounting
CAUTION
ENSURE THE UNIT IS MOUNTED IN A DRY ENVIRONMENT. DO NOT MOUNT
THE UNIT OVER A HEAT SOURCE OR IN DIRECT SUNLIGHT.
16. The unit may be mounted on a suitable horizontal shelf or wall-mounted using the
following procedure:
a) Referring to Figure 2 (or using the template supplied with the Serial Encoder), drill
holes to accept 8mm plugs and screws.
b) Fit the plugs into the holes and insert the screws into the plugs leaving 5mm
clearance between the screw heads and the wall.
c) Remove the four rubber feet from the base and slot the Serial Encoder onto the screw
heads.
NOTE: It may not be possible to carry out the Software Configuration using a
PC whilst the External Device is connected. It is recommended that
the Software Configuration is carried out before connecting the External
Device.