Manualshelf

User Manual

ManualsBrandsMultitone Electronics ManualsElectronicsMultitone I-Page – IP133
12345678910
NOTE: Any equipment and antenna that is installed within an area normally populated
whilst it is in use, must be located in a position where people may not approach, or be
located within 1m of the radiating antenna, for periods in excess of 5 mins. in any 1
hour. This distance is calculated to include an additional safety margin for the
product.
Compliance Information
EU Territories - This product complies with the requirements of the EU Radio &
Telecommunications Terminal Equipment Directive 99/5/EC. A complete copy of the
associated Declaration of Conformity for this and other Multitone products may be found at
the Multitone Internet address www.multitone.com.
This is Class 2 type equipment under the terms of the R & TTE Directive
and is therefore subject to restrictions in its use. Before installation and
use, consult your local radio communications spectrum authority, for
licensing and frequency regulations.
US & Canada - This product has been tested and certified for use in both the US and
Canada. Any modifications to this equipment not expressly authorised by Multitone, could
void the user's authority to operate the equipment.
(The term "IC:" before the certification/registration number, only signifies that the Industry
Canada technical specifications were met.)
Installation Notes
The equipment should be positioned so that there is no interference to the flow of air around
the unit and away from sources of heat. It should only be mounted to a wall, as
recommended in the installation instructions.
Care must be taken during installation to keep the power supply away from
excessive RF fields.
Where the transmitter power is to be greater than 2.5W, the antenna must be sited a
minimum of 1.5 metres away from the IP133 housing and power supply.
In cases where a close-coupled antenna must be used, the transmitter power must be
reduced to a maximum of 2.5W and care must be taken to position the antenna at least
0.5m from the power supply unit.
All installation wiring should be carried out in accordance with recognised Codes of Wiring
Practice, applicable to the equipment and circuits involved, e.g. Mains power, telephone
and/or radio. Power supply cords and other leads should be routed so that they are not likely
to be walked on, or pinched by items placed upon or against them.