User Manual

7 i-Page Installation & User Guide 9261-8879 Iss 2

5.5 Paging setup

The PAGING SETUP menu is used for setting basic message type details and an

engineering test for transmitter range.

The PAGER ADDRESS is a 7-digit number

consisting of a 3-digit SYSTEM ADDRESS

and a 4-digit USER NUMBER.

The pager address is also known as a RIC

or CAP CODE

5.6 Passwords

The web interface supports one administration password and one user password.

Only one administrator may be active at any one time and if a second administrator logs on

then the first will be logged off.

security level e.g. 2 very insecure passwords could be “paging” and “admin”.

Paging access can have an empty password, just hit submit, but an admin password must

be set. Up to five operators at Paging level can be simultaneously logged in to i-Page using

the same user password.

The web interface can be set to display in English, German, French, Spanish, Italian, Danish

and Norwegian.

5.7 Adding users

Your i-Page has been supplied with a number of pagers. Each pager must be programmed

to operate on the same frequency as your paging system.

You may add up to 256 users to i-Page.

Depending on your order requirements your pagers may have been pre-configured with a

pager address,(RIC/CAP CODE). The pager address, (RIC/CAP CODES) may be displayed

on the pager at start-up, depending on the pager type.

The pager address is a 7-digit number consisting of a 3-digit SYSTEM ADDRESS and a -

digit USER NUMBER. For example a pager address of 0011234, the user number would be

1234 and a pager address of 0010011, the user number would be 0011.

The pager user number is also known as a RIC code or CAP CODE.

A user number may be up to 4 digits long and is the four right-most numbers.

 System address – These are the left-most 3

digits of the pager address Code format –

Select one of the options provided. This

must be the same as your pager type

 Time of day – On or off

 Message length – Default is120 characters

 Coverage test – Is for service use and may

be used to identify locations where pagers

may not work. The test call is repeated to the

designated user number until disabled