User Manual

3 i-Page Installation & User Guide 9261-8879 Iss 2
4.0 Assembly requirements
4.1 Assembly
The installation of alarms and servicing of this product must only be carried out by
qualified personnel.
i-Page must be assembled with the following points in mind:-
 Transcoder must not be installed next to the power supply or aerial – place these
items as far away from the transcoder as possible, to ensure there is no interference
 i-Page requires an IP network connection within 2 metres
 A 120/230 volt mains socket must be within 3 metres of i-Page
 Computer with a browser such as Internet Explorer, Firefox or other
browser for programming i-Page
The IP133 i-Page can be wall or shelf mounted. i-Page is supplied for wall mounting and has
wall mount plates attached. For desktop mounting remove the wall plates and fix the
enclosed rubber feet.
An earth wire MUST be fitted to the 4mm earth screw terminal on the back of the transmitter
using the earthing lead supplied, or suitable equivalent.
4.2 Mounting
Attach the unit to the wall through the four mounting holes provided, using suitable fixings.
For desk or shelf mounting, remove the four screws using a 2.5mm Allen key and substitute
the four rubber feet supplied. Where this method of installation is used, ensure that the unit
is physically stable once all the leads have been connected.
Desk mounting
The unit must be on a stable surface and the correct distance away from power supply,
aerial or any other radio device.
4.3 Power supply
The power supply can be wall mounted using an optional mounting bracket. This item is an
accessory and may be purchased under part number 1061-8185-1.
The unit may be wall-mounted using the
procedure below.
If i-Page is to be fitted on a wall use the
mounting plates as a template and mark
the drilling points, (note: plugs and
screws are not provided.).