System Manual

EkoTek System Installation and Configuration Manual
9261-8173 issue: 8 Page 56
© 2012 Multitone Electronics Plc
Device mode
Each repeater is allocated a device mode (1-32), with 1 as default. However,
the name for each device mode can be user configured, in which case different
options will appear in this menu. The device mode defines the behaviours of
hubs (radio channel, alarm raising ability, etc).
Zone
Fixed devices are allocated a zone number, allowing alarms from mobile
devices to be sent to different pager groups based on the hub or repeater (and
therefore zone) that the mobile device is connected to, and for directly raising
location alarms. Up to 16 zones are supported by the EkoTek system.
After selecting the device mode parameters, click ‘Submit’ to enter the
changes.
Pager and call fob
Name
The name of the pager or call fob may be changed, by entering a new name in
the box.
Device mode
Each pager and call fob is allocated a device mode. The device mode defines
the alarms and location reporting. See the ‘Device mode’ section (page 60).
User group
Select from the drop list, to set ‘User Group’ (1-16). Used to route alarms to
different pager groups.
After selecting the device mode parameters, click ‘Submit’ to enter the
changes.