System Manual

EkoTek System Installation and Configuration Manual
9261-8173 issue: 8 Page 54
© 2012 Multitone Electronics Plc
1. The first column gives the hardware type and serial number of the device.
2. The second column gives the device name.
3. The third provides a ’Details ‘- button, to go to that specific device’s record.
The serial number of each device is displayed and the device name.
001-xxxxxxx indicates a hub.
002-xxxxxxx indicates a IP slave hub
004-xxxxxxx indicates an Ethernet Repeater
010-xxxxxxx indicates a call fob
020-xxxxxxx indicates a pager
030-xxxxxxx indicates a repeater
031-xxxxxxx indicates a solar repeater
040-xxxxxxx indicates a call point
Click the ‘Details’ button to see the device configuration.
Add
Click ‘Add’ at the bottom of the displayed list to go to the ‘Select device’ new
entry pages.
1. Select device type from menu.
2. Enter serial box and enter the serial number and name. The entry screen
below is for a repeater. Similar screens are shown for other device types,
with the appropriate hardware code displayed.
3. Click ‘Add’ to add the new device. If the entry is valid the individual device
entry page will then be displayed. If entry is not possible (invalid serial
number length, attempt to add a device prior to the hub, attempt to add a
second hub, too many devices already on-system, etc.) then ‘Invalid device
request’ will be displayed. If a device exists in the database with the same
serial number as the new requested device, the existing device details will
be displayed.