System Manual

EkoTek System Installation and Configuration Manual

9261-8173 issue: 8 Page 44

Each device in the mesh connects to the hub via a parent device (repeater or

directly to the hub itself). Maintaining this connection is important. These

statistics relate to that connection. Status reports are made every 4 hr 33 min 4

sec.

Device statuses in the list are highlighted as follows:

Low battery = yellow

Replace battery = red

Missed status report = yellow

Missed four consecutive status reports = red

Device status - hub and IP slave hub

Hub: Serial number.

Name: Name given to the hub.

Hardware - software: revision number.

Last report: Time and date stamp of last report.

Battery level: For the hub this will always be 100% when running on mains

power. Battery level (%) will be indicated when on backup power.

Upstream link: This will always be ‘Direct connection’. It is the topmost link of

the network.

Beacon loss count: This count records beacons lost since startup or reset.

Parent sync loss: Number of times that a loss of sync has occurred since

startup or reset.

Link quality: general quality of link to the hub, 1 to 100 where 100=best. Direct

connection is always 100.