System Manual

EkoTek System Installation and Configuration Manual
9261-8173 issue: 8 Page 33
© 2012 Multitone Electronics Plc
 In the box which appears, type HYPERTRM
 Click OK
If you see the error message 'Cannot find HYPERTRM' you will need to
install HyperTerminal:
 Click Start > Settings > Control Panel > Add / Remove Programs.
 In Add / Remove Programs select Properties and then click the
Windows Setup tab
 Double-click Communications
 Check the box for HyperTerminal
 Click OK, and then OK again to install
 Note: You may be asked for your Windows installation disk for this
procedure
3. When Hyper Terminal starts you will be presented with a 'Connection
description' dialogue box.
 Click 'Cancel' to continue
4. Select the preferred COM port:
 Select 'File' then 'Properties' from the menu bar and the 'New
connection properties' window will open
 Click on the arrow for the 'Connect using' drop down box
 Select 'Direct to ComX' (where X is the COM port you are using to
connect the modem - e.g. COM1, or COM5, etc)
 Click OK