System Manual

EkoTek System Installation and Configuration Manual

9261-8173 issue: 8 Page 26

Create an exit point for the wires from the mains powered repeater by removing

the section indicated in the illustration below with a pair of pliers.

Break away case here to

create exit point for wires.

Turn on the mains powered device by removing the link from the repeater PCB.

Wire the supply leads to the device using the screw terminals in the connecting

block. Note: Be careful to observe the correct polarity as shown on the label.

Before sliding the mains powered device back on to the base plate, offer the

device up to the base plate and plug the power connector into the circuit board.

Ensure the batteries are in place then slide the device on to the base plate.

Take care not to snag the power cable.

Wiring the call point to an external switch

The call point may be wired to an external switch if alarms are to be initiated

from a location that is remote from the call point.

Remove this connector if desired while

fitting the base plate. Remember to

reconnect it to complete the installation.

Connection block.

Observe polarity.

Remove this link and turn through

90 degs to be able to use to disable

battery in future