Manualshelf

User's Guide

ManualsBrandsMultitone Electronics ManualsElectronics2.4GHz Cordless Communication System Base Station
41424344454647484950
Page 49
Repeaters
By default, the Repeater will not be detected by the Kirktool software,
indicated by ‘Nothing Connected’ in the Status Message box. To allow the
software to detect the Repeater, you need to set the communication
method in the ‘Communication’ tab at the top.
Select the COM port you have attached the Repeater to (Usually COM1 or
COM2) and then click ‘Set Comport’. The Status Box should now indicate
that the Repeater is connected, and you are ready to configure the
Repeater.