User's Guide

Page 19
5.3 Setting up Repeaters
For the moment, it is recommended that you skip this section until the
Master Handset has been registered. You can then use that handset to test
the coverage and range of the CS100 Base Station, and use the results to
determine where your Repeaters should be located.
If you have weak spots within your office or work place, you can set up a
series of Repeaters to extend the coverage. It is important to place these
Repeaters in their optimum position so that the coverage area is increased
as much as possible.
For information on testing the coverage and signal strength, see section 5
‘Powering up and Testing’. Once you have determined where your weak
areas are, set up the Repeater and configure it using the instructions found
in Chapter 5. Finally, test the area again and ensure coverage is now
sufficient.
Repeaters can only be set up using a PC – NOT through the Master
handset.
BaseStation coverage area
Area covered by Repeaters
Equipment Installation