User's Guide

Page 43
Repeaters
5.2 Instructions for installation and configuration of
a Multitone Repeater
Repeater Installation
The following tools and software are required for the programming of
repeaters on the CS100
 Drill, Drill Bits, Rawlplugs and Screws
 Repeater Programming Kit - Part No. CS600 - PRG - Kit
 This includes a programming cable and special two way adaptor.
 Software must be downloaded from the Multitone web-site
www.multitone.com
Mounting the repeater
 Location
The repeater must be located within 3 metres of an ac mains outlet
socket. The socket should be marked “DO NOT TURN OFF”
 Power
The repeater must be located away from any structure or object that could
reduce or obstruct the radio transmissions. It is critical that the repeater is
tested in its preferred location before final fixing takes place.
Final Fixing
1. Pull the wire from the power supply, through the wall holder and then
mount the wall holder on the wall.
2. Connect the wire to the plug on the back of the WRFP and ‘click’ the
WRFP onto the wall holder.
If you need to remove the repeater, please separate it from the wall holder
with a gentle push of a screwdriver.
For further information and technical support please contact Multitone
Electronics website www.multitone.com