Installation Instructions

EkoTek System Installation and Configuration Manual Browser Interface
the edit. No rule table entry is shaded. Pressing submit will cause a conflict check, as
with the edit rule function.
User group: Select t he user group( s) using the rule.
Zon e: Select the zone( s) using the rule.
Tim e of day: Select the day and/or night settings of the system.
Escalat ion: The escalation level of the alarm. R = Raised, N=Normal
Pa ge r Group: Select a pager group.
Subm it : The submission of the rule will cause a check for rule conflicts: any
specified alarm event must only result in a single pager group target. If a conflict is
detected the change is not made, the edit rules detail table will remain on the page
(with the requested new settings) in order to enable the conflict to be resolved.
After a successful subm ission the Alert Mapping page shows t he new rule
added t o the list .
Factory reset
Click ‘Factory Reset’ button to return network to factory settings (all devices deleted, IP
addresses reset etc). The following text appears: ‘Proceeding with this action will delete all
devices from the database and return all settings to factory values’.
Delete all devices
Click the ‘Clear database’ button to clear the database of all network devices, but leave
passwords, IP addresses etc. as set.
The following text appears: ‘Proceeding with this action will delete all devices from the
database’.
9261-8173 Issue 2
Page 45
© 2007 Multitone Electronics PLC