Installation Instructions

EkoTek System Installation and Configuration Manual Browser Interface
Opera t ion :
Define how many button presses are required to trigger the manual alarm (one or
two) selected by drop-down menu. Single click, Double click.
Alarm a udible aler t :
Define whether device buzzer sounds when manual alarm is raised.
Alarm vibrate alert:
Define whether the vibrate motor is activated when a manual alarm is raised.
Deadman alarm enable:
Enable the deadman automatic alarm. This is raised if input is not received from the User,
when prompted by the device.
Alert text:
Modifiable text appears in the message sent to Pagers, when this alarm is activated.
Defaults to: No response.
Timer interval:
Time between user input prompts (minutes).
User alert period:
Time that the buzzer prompt sounds on the device without user input, before the
alarm is raised (seconds).
Mandown alarm enable:
Enable the tip over switch automatic alarm; will raise an alarm if the unit has been moved
away from an upright position for a defined period of time.
Alert text:
Modifiable text appears in the message sent to pagers when this alarm is activated.
Defaults to: Man over.
Tipover trigger period:
Length of time a device must be moved away from upright, until the User warning
buzzer sounds (seconds).
User alert period:
Length of time that the buzzer sounds on the device, without it being returned to the
upright position and the cancel button pressed, before the alarm is raised (seconds).
Alarm clearance - Alert text:
Sets the text to appear in the message sent to Pagers, when any alarm for this device is
cleared. Defaults to: Cleared.
Alarm escalation period:
If an active alarm is not cleared within this period of time, then the device re-sends the
alarm with a raised escalation level (minutes).
Enable location reports:
If selected, then the ‘locate mobile device’ page will display the last known location of this
device.
Submit:
Submit the requested configuration.
Pager groups
These pages are used to manage Hubs and display Pagers into groups. Devices may
appear in none, one or many Pager groups. Each group is restricted to thirty-five devices.
9261-8173 Issue 2
Page 42
© 2007 Multitone Electronics PLC