Installation Instructions
Table Of Contents
- Approvals
- System Overview
- Network Design and Survey
- Installation
- Pre-requisites
- Installing the Hub
- Repeaters
- PPP Modem
- The Browser Interface
- Accessing the HUB with the browser interface
- Connect the Hub to the PC using Windows XP
- Using the Web Browser to Access the EkoTek Hub
- Main menus
- Maintenance Menus
- Configuration menus
- Final Checks
- Appendices
- Related Documentation and Revision History
EkoTek System Installation and Configuration Manual Browser Interface
System Settings
This page sets the network interfaces. It enables set up of Hub settings, clock, external
connections and the browser language.
Click ‘Configuration’ and select ‘system’.
Set Clock
The clock operates in two modes, one displaying the current time (if JavaScript is enabled
on the browser this will update, if not then the clock is a snapshot of the time the page was
loaded).
1. Click the details button and enter the current time and date.
2. Click submit to set.
Note: An illegal clock setting will return to clock display mode, but the original settings will
be retained.
Hub IP configuration
If the Hub is to be connected to an Ethernet Server/Network, then the IP address, subnet
mask and gateway should be set within the address range of the network, to allow the Hub
to be accessed from the network. Once the IP address is configured, then the Hub can
only be accessed using that IP address, so a note should be made of any IP address that
is set.
Note: An illegal IP setting will return to system settings and the original settings will be
retained.
9261-8173 Issue 2
Page 33
© 2007 Multitone Electronics PLC